![on screen display menu on screen display menu](http://www.mhmfun.com/imageservice/images/img/13/pages/topcats/digital-display/digital-display-menus-1.png)
: A memory card that cannot record is inserted (the card is recognized but cannot record due to a format error, a card other than a memory card being inserted, etc.) : No remaining recording capacity (no remaining recording capacity on the memory card) : Write protected (the write protection switch of the memory card is set to the LOCK side) The recording capacity available for simultaneous recording (recording capacity for the memory card of the two memory cards with less recording capacity) is displayed when simultaneous recording is performed. The display will flash when the remaining recording capacity becomes two minutes or less. to : Remaining recording capacity (999 minutes or more is displayed as ) Remaining recording capacity and status of the memory card (card slot 1)ĭisplays the remaining recording capacity and status of the memory card in card slot 1. The tally lamp is not instructed to illuminate in red/green via network, and the menu → → is set.
![on screen display menu on screen display menu](http://cdn1.expertreviews.co.uk/sites/expertreviews/files/2015/11/full_screen_start_menu.png)
(No display): It is in one of the following conditions. : The tally lamp is instructed to illuminate in green via network while the recording is stopped. : The tally lamp is instructed to illuminate in red via network. : Pre-recording is enabled, and the memory card is not inserted in the card slot, or the memory card is not recognized. : Recording is stopped with pre-recording is enabled and the recording target memory card is inserted. (Flashing red dot): Processing to stop the recording. : The recording is stopped while the recording target memory card is inserted. Message display area for stop of cooling fanĭisplays a message when the cooling fan has stopped.ĭisplays the recording status of the memory card in card slot 1. (No display): It is not displayed when set to the menu → → and the menu → →. : Displayed when set to the menu → → and the menu → →. : Frame rate is displayed when set to the menu → →. This is displayed when the menu → → is set. : Displays the cumulative counter value from the reset position. Displays the counter value of the clip being played back during playback. This is displayed when the menu → is set to.
![on screen display menu on screen display menu](https://www.kuusoft.com/nexsigns/wp-content/uploads/sites/11/2018/08/Screen-3-1.jpg)
: Displays the counter value of each clip. is displayed with black and white inverted during the slave lock into the external input time code. Share your experience below in the comments section.The display will toggle to the next display or no display every time the button is pressed. Hopefully, one of the above fixes worked for you. This should allow you to start the application new, and hopefully where it’s back on the screen. From there, select the application, then “ Force Quit“. Try selecting “ Apple” Menu, then “ Force Quit…“. Some MacBooks may require you to press “ Command” + “ Fn” + “ F1” Fix 5 – Force Quit Try toggling mirror settings by holding “ Command” and pressing “ F1“.
![on screen display menu on screen display menu](https://www.eightforums.com/data/attachments/20/20308-4471dcd0cb7b2cb48149ec950d009f2c.jpg)
Change the resolution setting back to the desired setting.This should force the window for the application back on the screen where you can drag it to a safe place. Ensure “ Scaled” is selected under “ Resolution“.Select the Apple Menu, then choose “ System Preferences…” > “ Displays“.Select the application in the dock, then choose “ Window” > “ Zoom“.